Jetstream Mini A
The Mini A is a pre-programmed double nozzle machine capable of operating as part of a permanently installed system for water/crude oil washing or as a portable unit being supplied by a 50mm (2") bonded hose.

A range of nozzle sizes is available to comply with your specification for jetlength and fluid throughput A choice of three cycle speeds can be factory preset into each machine to ensure thorough and complete coverage of all sizes of tanks.

The drive mechanism of the Mini A enables operation to commence at very low pressures (3.5 kg/cm² - 50 psi) therefore making it ideally suited to not only conventionally equipped vessels but also to dry cargo carriers using water from the fireline.

All machines are provided with an illustrated operating and maintance manual and a "first-aid" repair outfit to assist with routine maintance. Service centres offering repair facilities and technical assistance are available in many of the worlds major ports.
Performance Specification:

Supp. Pres- sure kg cm²	Typical Nozzle Diameter
	10mm		12mm		14mm		16mm		18mm		20mm
	Flow m³/ hr	Jet- len- gth /m	Flow m³/ hr	Jet- len- gth /m	Flow m³/ hr	Jet- len- gth /m	Flow m³/ hr	Jet- len- gth /m	Flow m³/ hr	Jet- len- gth /m	Flow m³/ hr	Jet- len- gth /m
8	28	13	35	13	41	16	54	22	62	21	75	22
10	33	15	41	19	47	22	61	23	68	24	85	25
12	38	16	46	20	53	23	67	25	74	26	94	27

(Extract from Department of Trade Certificates)

Operating Temperature Range:	Upto 100ºc
Cycle Times Available:	15, 30 and 45 minutes
Typical Inlet Connections:	2½" - 7½ TPI Male
Typical Fixed Inlet Connections:	PN16 -50mm NB Flange
Alternative connections are available on request
Dimensions: (Figures below quoted in () refer to High Capacity Machine 16, 18, 20mm)
	Portable Machine	Fixed Machine
Length:	240mm	258mm (270mm)
Width:	172mm	192mm (192mm)
Height:	375mm	357mm (361mm)
Weight:	26kgs (28kgs)	27kgs (29kgs)
Minimum Deck Opening:	250mm	268mm (280mm)
Overall Nozzle Length:	408mm(668mm)	408mm (668mm)

---

Click here to go back to the previous page

---